Advanced search
Start date
(Reference retrieved automatically from Web of Science through information on FAPESP grant and its corresponding number as mentioned in the publication by the authors.)

Cooling thermal parameters, microstructure, segregation and hardness in directionally solidified Al-Sn-(Si;Cu) alloys

Full text
Bertelli, Felipe [1] ; Brito, Crystopher [1] ; Ferreira, Ivaldo L. [2] ; Reinhart, Guillaume [3] ; Nguyen-Thi, Henri [3] ; Mangelinck-Noel, Nathalie [3] ; Cheung, Noe [1] ; Garcia, Amauri [1]
Total Authors: 8
[1] Univ Estadual Campinas, UNICAMP, Dept Mfg & Mat Engn, BR-13083970 Campinas, SP - Brazil
[2] Univ Fed Fluminense, Dept Mech Engn, BR-27255125 Volta Redonda, RJ - Brazil
[3] Aix Marseille Univ, Inst Mat Microelect & Nanosci Provence, F-13397 Marseille 20 - France
Total Affiliations: 3
Document type: Journal article
Source: MATERIALS & DESIGN; v. 72, p. 31-42, MAY 5 2015.
Web of Science Citations: 20

The morphology and length scale of the phases forming the microstructure of sliding bearing alloys are known to affect wear, mechanical and corrosion resistances. Al-Sn alloys have good anti-frictional properties due to the presence of Sn. However, with the current trends in engine design, these alloys are not able to support the demanded heavy loads. An alternative way to reach this requirement can be the alloying with third elements such as Si and Cu. Despite the importance of their application properties, studies on the development of microstructures of these multicomponent alloys are rare in the literature. In the present investigation Al-Sn-(Cu;Si) alloys were directionally solidified (DS) under transient heat flow conditions, and a thorough characterization is performed including experimental growth rates and cooling rates, segregation, optical and scanning electron microscopies and primary dendrite arm spacings, lambda(1). Experimental growth laws are proposed relating the dendritic spacing to solidification thermal parameters. Furthermore, the scale of the dendritic morphology, the distribution of second phases in interdendritic regions and the macrosegregation pattern are shown to affect the hardness along the length of the DS castings. Hall-Petch type equations are proposed relating hardness to lambda(1). (C) 2015 Elsevier Ltd. All rights reserved. (AU)

FAPESP's process: 12/08494-0 - Thermal and Microstructural Parameters in the Transient Solidification of Al-Mg and Al-Mg-Si Alloys and Correlation with Mechanical and Corrosion Resistances
Grantee:Crystopher Cardoso de Brito
Support type: Scholarships in Brazil - Doctorate
FAPESP's process: 12/16328-2 - The Correlation between Solidification Microstructures and Mechanical and Tribological Properties of Al-Sn-Cu and Al-Sn-Si Alloys
Grantee:Felipe Bertelli
Support type: Scholarships in Brazil - Post-Doctorate
FAPESP's process: 13/23396-7 - Effects of solidification MicrostructureParameters of Aluminum-based multicomponent alloys (Al-Mg-Si; Al-Sn-Cu; Al-Zn-Mg) on the resistances to Corrosionand tribocorrosion degradation
Grantee:Amauri Garcia
Support type: Regular Research Grants
FAPESP's process: 14/21893-6 - The correlation between solidification microstructures and mechanical and tribological properties of Al-Sn-Cu and Al-Sn-Si alloys
Grantee:Felipe Bertelli
Support type: Scholarships abroad - Research Internship - Post-doctor